Netopia Firmware 4000-Series - Manual (Page 188)

6-36 Firmware User Guide
Typically, you will have a Connection Profile that you created in Easy Setup. You may have more. Select the
Connection Profile that you want to use from the Display/Change Connection Profile menu, and then select IP
Profile Parameters.
By default, Multicast For warding is turned off (None) on Connection Profiles until you enable a specific
Connection Profile to receive multicast data. You enable it by selecting Rx. from the pull-down menu.
IP Profile Parameters
Address Translation Enabled: Yes
IP Addressing... Numbered
NAT Map List... Easy-PAT List
NAT Server List... Easy-Servers
Local WAN IP Address: 0.0.0.0
Local WAN IP Mask: 0.0.0.0
Remote IP Address: 0.0.0.0
Remote IP Mask: 0.0.0.0
Filter Set... +----------------+
Remove Filter Set +----------------+
| None |
| Rx. |
+----------------+
Multicast Forwarding...
RIP Profile Options...