Netopia Firmware 4000-Series User Manual
Page 16
1-6 Firmware User Guide
Launch your terminal emulation software and configure the communications software for the values shown in
the table below. These are the default communication parameters that the Netopia Firmware Version 5.4 uses.
Parameter
Suggested Value
Terminal type
PC
: ANSI-BBS
Mac
: ANSI, VT-100, or VT-200
Data bits
8
Parity
None
Stop bits
1
Speed
9600 - 57600 bits per second
Flow Control
None
Note:
The router firmware contains an autobaud detection feature. If you are at any screen on the
serial console, you can change your baud rate and press Return (HyperTerminal for the PC
requires a disconnect). The new baud rate is displayed at the bottom of the screen.