Nortel Networks CALLPILOT 555-7101-217 - Manual (Page 60)

Installing the server and connecting the peripheral devices Standard 1.0
60 CallPilot
To connect the mouse, keyboard, and monitor to the server
1 Place the monitor, keyboard, and mouse in the same location as the
server.
2 Plug the keyboard and mouse into the appropriate PS/2 connectors on
the SBC. See the “Rear panel connections” on page 59.
3 Plug in the monitor to the video connector on the video card. Tighten the
screws on the connector. See the “Rear panel connections” on page 59.
4 Connect the power cord to the monitor, and plug the other end into a wall
receptacle or power bar.
5 Turn on the monitor.
To connect the modem to the server
1 Ensure that the modem’s AC power cord is not plugged in.
2 Connect the large 25-pin male connector to the back of the modem.
Tighten the connector screws.
3 Connect the 9-pin female connector to COM1 at the rear of the server.
Tighten the connector screws.
4 Connect one end of the telephone cable to the modem RJ-11 jack
labeled LINE.
5 Connect the other end of the telephone cable to the RJ-11 jack in the
wall.
.
CAUTION
Risk of system failure
You can install or use only Nortel Networks approved
peripheral devices on your server. Installation or use of
unapproved peripheral devices can result in system failure.