Nortel Networks CALLPILOT 555-7101-217 - Manual (Page 42)

Power supply installation Standard 1.0
42 CallPilot
To install the power supply module
The server is shipped with one power supply module installed in the bottom
power supply bay. You must install the second power supply module, as
described here:
1 Align the power supply module with the top power supply bay.
2 Slide the power supply module into the bay until the module is secured
by its connector.
Use some force, if necessary.
3 Secure the power supply module to the chassis with two thumbscrews at
the corners of the power supply faceplate.
What’s next?
Do one of the following:
.
DANGER
Risk of electric shock
High current inside the chassis can cause severe injury.
IF THEN
this is an AC-powered server continue with Chapter 4, “Installing
the server and connecting the
peripheral devices,” on page 53.
this is a DC-powered server continue with Section B: “Setting up
DC power source for a 1001rp DC
server,” on page 43.