Unpacking the 1001rp server – Nortel Networks CALLPILOT 555-7101-217 User Manual
Page 29

May 2003
Preparing for installation
Part 2: 1001rp Server Hardware Installation
29
Unpacking the 1001rp server
Introduction
Follow this procedure to unpack the server and peripherals.
To unpack the equipment
1 Carefully open the cardboard carton containing the server.
2 Remove the server from the carton and set it on the floor.
3 Carefully open the cartons containing the monitor, keyboard, mouse,
modem, and ELAN hub (if supplied), and set the peripherals aside.
4 Put all manuals, CD-ROMs, operating system disks, any disks for
peripherals, and the Windows NT emergency repair disk in a safe place.
.
WARNING
Risk of personal injury
The 1001rp CallPilot server weighs approximately 34 kg
(75 lbs) as shipped from manufacturing. To prevent personal
injury, have someone help you to unpack and position the
server.
ATTENTION
As you unpack each item, check it off against the
packing list, as well as against the following
checklists provided in Part 1 of the CallPilot
Installation and Configuration binder:
“CallPilot software media and documentation
checklist”
“CallPilot server hardware checklist”