NEC Dterm PSIII - Manual (Page 38)

32
To Set the Call Forwarding Busy Cancel
Access Code:
♦ Press the FNC key →3→5→1. PSIII displays:
♦ Press the FNC key or 2. For Mode 2* systems,
PSIII displays:
♦ Key in the access code to cancel call forwarding.
Example: #3=Call Forward Busy, Cancel.
♦ Press the FNC key to enter.
♦ Press the FNC key to confirm.
♦ Setting tone will ring.
♦ After two seconds, return to the standby state.
[Call Forwarding Don’t Answer]
Enables you to set the access code which is used to
establish Call Forwarding when you do not answer
the phone.
NOTE: Confirm your system administrator for
the list of access codes.
To Set the Call Forwarding Don’t Answer
Access Code:
♦ Press the FNC key →3→5→2. PSIII displays:
♦ Press the FNC key or 1. For Mode 2* systems,
PSIII displays:
* Mode 2 features are only available on NEAX 2000 IVS Series 1900 software
or NEAX 2400 IMX Series 7300 software & Zone Transceiver Version 5.00
software or later.
[1]Set
[2]Reset
CFW Busy
Access No?
[1]Set
[2]Reset
CFW D/A
Access No?