Polycom 1 - Manual (Page 13)

Introducing the Polycom HDX Systems
1 - 3
To power off the Polycom HDX system:
¾ Press and hold the power button on the remote control for 2 seconds.
¾ Press and hold the power switch on the front of the system for 2 seconds.
The following figure shows the location of the power switch and indicator
light.
The indicator light on the front of the system provides this information:
Indicator Light System Status
Off System is powered off
Steady green light System is initializing
System is awake and not in a call
Blinking green light (once) System received an IR signal while
awake and not in a call
Blinking green light (on 1 sec, off 2 sec) System is asleep, not in a call
Steady amber light System is in a call
Blinking amber light (once) System received an IR signal while in
a call
Blinking amber light System is in software update mode
System is in factory restore mode
Rapidly blinking amber light System is preparing to reset its
configuration