Polycom 1725-31402-001 - Manual (Page 49)

Release Notes - UC Software Changes
Copyright © 2011 Polycom, Inc. Page 41

62567: SoundPoint IP 3xx: Phones monitoring each other in a 2x2 BLA
configuration are not able to pick up held calls.

62621: SoundPoint IP 3xx: Phones configured for HTTPS are displaying error
messages “Alert:Fatal, Description: Decode Error”.

62642: Phones play “dial tone” as well as RTP audio when resuming a call held at
another phone.

62643: SoundPoint IP 3xx: When the user presses both line keys (Line 1-hold and
Line 2-Active call) simultaneously, the active call on Line 2 is dropped.

62669: Multiple phones try to resume a held Bridge Line Appearance BLA line at
the same time. As a result, presence indicator on the BLA line is cleared on the
trailing phone when the reorder tone is played.

62672: Either Directed Call Pickup DCP or Group Call Pickup feature (using soft
keys instead of *53 and *54 feature access codes) fails when the user must enter
an account code. The account code is not appended to the user portion of the
URI.

62855: SoundPoint IP 3xx: Invoking either the Group Call Pickup or Directed Call
Pickup feature, using its corresponding soft key, does not function properly. The
display shows “Unknown” and the call is not picked up.

62902: The phone will not accept inbound SIP requests from a RROFO (Geo-
redundancy) server that is not registered with that phone.

62926: SoundPoint IP 3xx: The “Resume” soft key is not presented when the line
key is pressed continuously while the line is in a remote held call state. This
occurs when the line is configured as callsPerLineKey="1".

63099:
The phone‟s monitoring Bridged Line Appearance BLA line, configured
for one call per line, cannot pickup the held call after the call on a BLA line has
been put on hold using the Transfer/Conference key.

63280: [Geo-redundancy RROFO]: Calls on hold are not released when pressing
the “Resume” soft key after the IPBE fail-over occurs while using the “geo-
redundancy” feature. The user must also press the “End Call” soft key to
complete the intended result.

63388: [Emergency Call Routing]: If a phone‟s SIP lines are not registered with a
call server, and the Emergency Call Routing Feature is enabled (by configuring
the
dialplan.routing.emergency.x.value and dialplan.routing.emergency.x.server.y
parameters) dialing the configured emergency number will only work if you use
on-hook dialing and when URL Dialing is enabled. With the VVX 1500, this feature
does not function using either on and off-hook dialing.
You will not be able to dial the emergency number (using either on-hook or off-
hook dialing) if URL Dialing is disabled.

63536: The “Redial” feature fails to function correctly after invoking an outgoing
call accompanied with an account code.

63631: [Geo-redundancy RROFO]:
The counting down aspect of the “Geo-
redundancy RROFO- DNSTTL” feature fails during fail-back. The Time-To-Live
TTL timer should be reset after re-registering to the secondary server.