Philips M3860A - Manual (Page 92)

M3860A/M3861A HEARTSTART FR2+
D-4
P
h
ili
ps
Me
dic
a
l
Sy
s
tem
s
rhythm analysis ...................... See “ SMART analysis.”
send (data) ............................. A feature of the HeartStart FR2+ that allows use of its infrared (IR)
communications port to send data directly to another FR2+ or a computer
running HeartStart Event Review Web software.
sensitivity ................................ A measure of the ability of the HeartStart FR2+ to reliably detect and identify
shockable heart rhythms.
setup ........................................ The settings of all programmable operating parameters of the HeartStart
FR2+. The factory default setup can be modified using the M3864A training
& administration pack.
shock series ........................... One or more shocks, each separated by no more than a preset time
(programmed Protocol Timeout). After completion of a shock series, the
HeartStart FR2+ automatically pauses for CPR.
shockable rhythm .................. Ventricular fibrillation and certain ventricular tachycardias associated with
sudden cardiac arrest.
shock waveform ..................... See “ SMART biphasic waveform.”
SMART analysis ...................... The proprietary algorithm used by the FR2+ to analyze the patient’s heart
rhythm and determine whether a shock is advised.
SMART biphasic
waveform
............................ The patented, low-energy defibrillation shock waveform used by the FR2+. It
is an impedance-compensated biphasic waveform with 150 Joules, nominal,
delivered to a 50 ohm load. When delivered via FR2 infant/child
reduced-energy defibrillator pads, the energy is attenuated to 50 Joules,
nominal.
specificity ................................ A measure of the ability of the HeartStart FR2+ to reliably detect and identify
non-shockable heart rhythms.
standard battery ...................... The M3863A battery, 12 VDC, 4.2 Ah, lithium manganese dioxide,
disposable, long-life primary cell.
standby mode ........................ The operating mode of the HeartStart FR2+ when a battery has been
installed, and the unit is turned off and ready for use when needed. Shown by
flashing black hourglass on the Status Indicator.
status indicator ...................... This is a special window in the upper right-hand corner of the front panel of
the HeartStart FR2+ that lets you know the status of the device.
sudden cardiac
arrest
................................... The sudden cessation of the heart’s pumping rhythm.