Philips DVDR3370H - Manual (Page 97)

85
Fit to space Recording
You can select also the recording mode 'FR' .
With these setting the recording mode (bit rate) will be automatically
calculated to use the complete empty space (title 'Empty').
If the empty space is too small the recording will be stopped to prevent
the following titles from being overwritten.
Do not use this function under the following conditions:
•) more then one programmed recording
•) daily/weekly repeated recordings
May be the calculation of the recording mode can not function properly.
Tip
7 If all information is correct, press the OK button. The
information is stored in a TIMER block.
8 To end, press TIMER s .
9 Insert a recordable disc in the Recorder.
The disc is checked.
10 Locate on the disc the position where you want to start the
recording. Press STOP
h .
11 Switch the Recorder off with STANDBY m .
The programmed recording will only function properly when the
DVD
Recorder has been switched off using the
STANDBY m button.
If any of the TIMER blocks are in use, 'TIMER' will light up on the display.
Programming a recording without the
VCR Plus+
® system
1 Switch on the TV. Select the channel number for the DVD
Recorder (channel 3 or 4 or the Audio/Video In channel).
2 With the Recorder on, press TIMER s on the remote control.
The programming method selected last is marked.
Timer
Timer Programming
Date
01/22 Ch.
01 Start
08:30AM End
10:00PM
Rec
Mode
M1
Mo-Fr/Weekly
Press SELECT To store
Press OK
3 Select line 'Timer Programming' using B or A and confirm
with C .
The information will be displayed.
4 Select the entry field with D or C .
5 Enter information with B , A or the number buttons 0..9 .
In the entry field 'Date', you first enter the month and then the
date.
ENGLISH
Programming a recording (TIMER)