Philips DVDR3370H User Manual

Page 27

Connect the mains jack

4MAINS at the back of the DVD

Recorder with the power supply using the supplied power cable.
The most important features of the DVD Recorder will appear
on the display.
After the initial installation is completed, this function will be
switched off. How you switch on this function again, read in the
chapter 'User preferences' in the section 'Standby'.

Press

STANDBY-ON

m on the recorder. 'IS TV ON?' will

appear on the display.

Then, read the paragraph 'Initial installation' in the chapter 'Installing your DVD recorder'.

Connecting with Video (CVBS) cable

This cable, usually featuring yellow cinch plugs, is used for transmitting the Composite Video
signal (FBAS, CVBS). In this method of transmission the color signal and the brightness signal are
transmitted on the same cable. Under certain circumstances, this may lead to problems with the
picture, such as 'Moiré' patterns.

Have the following cables ready:
an antenna cable (1, supplied), a power cable (2, supplied), a video (CVBS) cable (3, with yellow
ends), and an audio cable (4 with red/white ends).

Remove the antenna or cable TV signal from your TV. Connect it
to the ANTENNA IN jack at the back of the DVD recorder.

Insert one end of the supplied antenna cable into the

OUT jack at the back of the DVD Recorder and the other end
into the antenna input jack at the back of the TV.

Use a video (CVBS) cable and plug one end into the yellow jack

VIDEO (CVBS) OUT at the back of the DVD Recorder and the

other end into the Video In jack (usually yellow) of the TV
(usually called Video in or AV in. See your TV's instruction
manual).

Use an audio (cinch) cable and plug one end into the red/white
cinch jack AUDIO L/R OUT at the back of the DVD Recorder
(under to Video in ) and the other into the corresponding
red/white audio input jack of the TV (usually called Audio in', 'AV
in'. See your TV's instruction manual).

ENGLISH

Connecting the DVD Recorder