Panasonic DP-C106 - Manual (Page 37)

Setting Up the DP-C106 Unpacking the Printer
1-16
o. Gently pull the handle until the Bypass Transport is completely
opened, then remove the two spacers labeled D.
p. Close the Bypass Transport.
11. Close the Front Cover.
12. After installing the Printer on the System Console, perform the following
steps:
a. Remove the Rear Connector Cover from the rear of the Printer by
pressing down on the release latch while grasping under the Rear
Connector Cover, then pull it away from the Printer.