Panasonic DP-C106 - Manual (Page 144)

Setting Up the Network Server
6–9
Configuring a Windows NT 4.0 Server
Use the following procedure to configure a Windows NT 4.0 server to
communicate with the DP-C106. Basic steps include:
•
Load the TCP/IP network protocol and configure it with an IP
address, subnet mask and gateway.
•
Enter the host name of the DP-C106 in the host database
•
Perform Printer Setup.
•
On the Windows NT 4.0 server, create a printer for each print
connection, install the appropriate printer drivers, and (optionally)
share the printer on the network.
•
Enter the host name and remote printer name of the DP-C106 in
the printer connection.
•
If the Windows NT 4.0 server is also a workstation, install the
Fiery utilities.
More detail is provided in subsequent chapters and in your Microsoft
documentation.
Adding the DP-C106 to the TCP/IP Network
(Windows NT 4.0)
If your TCP/IP network consists of Windows NT 4.0 servers and
Windows NT 4.0 clients, perform the following procedure.
1. Register the IP address of the printer in the host name database
used by your system.
For installations that do not have a system administrator or a
central host name database, add the printer to the hosts file on
the Windows NT 4.0 server.
Add the printer to the hosts file on any workstations that have
TCP/IP loaded and will use the Fiery Utilities.