Philips P2HD AG-HPX170P - Manual (Page 78)

78
Connecting external units (continued)
When connecting the unit to an Apple Macintosh computer
Connect the 1394 cable after turning on the power of the Apple Macintosh computer. Otherwise, the unit
may not be mounted.
The unit may not be recognized after the Apple Macintosh computer has been placed in the hibernation
state by its power-saving setting. In this case, disconnect the 1394 cable and then re-connect it.
If the unit is not mounted properly on an Apple Macintosh computer
When the P2 card access lamp flashes orange
1. Select [Applications] " [Utilities] " and start up [Disc Utility].
2. Select a grayed-out volume among volumes of the X.X GB Panasonic disc, and click “Mount.”
When the P2 card access lamp is off
Eject the P2 card, and insert it again. If the unit is still not mounted, disconnect the 1394 cable and then
re-connect it.
Hard disk drive (data copying)
1394
Hard disk drive
-pin
19 cable (optional)
Ferrite core (included)
Before proceeding to connect or disconnect 1394 cable, be absolutely sure to turn off the power of the
units.
Before proceeding to connect the unit which uses a 6-pin type 1394
connector, carefully check the shape of the 1394 cable and the connectors
on the 1394 cable. Connecting a connector upside down may damage the
parts inside the unit and cause malfunctioning. The above also applies to
USB cable as well.
When connecting to a device having 4-pin type 1394 connector, first
connect the cable to the 6-pin type 1394 connector on the camera.
Do not apply force when connecting 1394 cable to 1394 connector as this
may damage the connector.
•
•
•
•
•
•
•
•
-pin type -pin type -pin type -pin type