Philips P2HD AG-HPX170P - Manual (Page 107)

Men
u
107
PLAYBACK FUNCTIONS screen
Item
Display
mode
Description of settings
AUDIO OUT (MCR) Sets the audio signals to output from the AUDIO OUT pin jack when
the P2 card or the tape is played back.
CH1 · CH:
CH1 output = CH1 signals, CH2 output = CH2 signals
CH1:
CH1 output = CH1 signals, CH2 output = CH1 signals
CH:
CH1 output = CH2 signals, CH2 output = CH2 signals
CH · CH:
CH1 output = CH3 signals, CH2 output = CH4 signals
CH:
CH1 output = CH3 signals, CH2 output = CH3 signals
CH:
CH1 output = CH4 signals, CH2 output = CH4 signals
AV IN/OUT SETUP screen
Item
Display
mode
Description of settings
CMPNT/SDI SEL (Camera)
(MCR)
Selects the type of component terminal or SDI connector.
AUTO: Monitor with D4 terminal (720P/1080i/480i output)
1080i: Monitor with D3 terminal (1080i/480i output)
80i: Monitor with D1 terminal (480i output)
Only video recorded at 720P is cross-converted to 1080i. Cross-
conversion does not take place in other cases.
SDI OUT (Camera)
(MCR)
Selects video output from component terminal or SDI OUT terminal.
ON: Video is not output via the component terminal but from the SDI
connector.
OFF: Video is output via the component terminal but not from the SDI
connector.
SDI METADATA (Camera)
(MCR)
Determines whether or not metadata is superimposed on SDI signals
during HD-SDI output.
ON: Superimposes metadata.
OFF: Does not superimpose metadata.
SDI EDH (Camera)
(MCR)
Determines whether or not EDH is superimposed on SD-SDI signals
during SD-SDI output.
ON: Superimposes EDH.
OFF: Does not superimpose EDH.
DOWNCON MODE (Camera)
(MCR)
Switches down-conversion output mode.
SIDE CROP: Crops the right and left edges of the images with the 4:3
aspect ratio.
LETTER BOX: Adds black bands at the top and bottom of the images,
and the images with the 16:9 aspect ratio are displayed in the 4:3
aspect ratio.
SQUEEZE: Select this option for 16:9 aspect ratio images. When
viewed on a 4:3 aspect ratio monitor, images are squeezed horizontally.
HP MODE (Camera) Selects the sound heard through the headphones.
LIVE:
The sound which has been input from the microphone is output as is.
This setting is selected when delays in the sound are annoying.
RECORDING:
The sound in the status which is to be recorded (the sound
synchronized with the images) is output.
TEST TONE (Camera) Determines whether or not a test tone is output to channels 1, 2, 3 and
4 when BARS is set to ON.
ON: Outputs a test tone to channels 1, 2, 3 and 4.
The reference level is -12 dB.
OFF: Does not output a test tone.
•
___indicates the factory setting.