Philips P2HD AG-HPX170P - Manual (Page 113)

Ref
erence
11
Before calling for service
Power supply
There’s no power. Make sure the battery and AC adapter are connected properly.
Check the connections again. • P16
Power shuts off for no
apparent reason. To prevent the battery from running down needlessly, the camera-
recorder automatically turns off when the camera-recorder has
been left in the shooting pause mode for more than 5 minutes.
Check the settings in the OTHER FUNCTIONS screen, POWER
SAVE. • P112
Power goes off as soon as
it is turned on. The battery may have run out.
If the remaining battery charge display is blinking or
appears, the battery has run out. The same is true if, when the
power is turned on, the CAM, MCR and PC lamps flash in this
sequence and then the power goes off.
Either recharge the battery or replace the discharged battery with
a fully charged one.
• P15
Battery
The battery runs down
quickly. Make sure the battery is fully charged.
Keep charging until the AC adapter’s CHARGE lamp goes out. • P15
Are you using the battery in a cold place?
The battery is affected by the ambient temperature. Its operating
time is reduced in low-temperatures. • ——
The battery may have reached the end of its service life.
The battery will become unchargeable. The battery has a certain
service life which varies depending on how the battery is used.
If the battery operates only for a short period even when it is
charged adequately, it has reached the end of its service life. • ——
The battery cannot be
charged. The battery cannot be charged if the DC cord is connected.
Disconnect it. • ——
Reference