Philips P2HD AG-HPX170P - Manual (Page 16)

1
Installing and removing the power supply
Installing and removing the battery
Installation
1
Insert the battery until it clicks into place.
Removal
1
Set the POWER switch to OFF, and check
that the mode lamp is off.
While pressing the battery release button,
raise up the battery to remove it.
Support the battery with your hand to ensure
that it will not fall.
Battery release button
Mode lamp
•
Connecting and disconnecting the power cord
Installation
1
Connect the DC cord to the AC adapter.
Plug the AC power supply cord into the
power outlet.
Slide the DC cord’s battery connector to
the direction of the arrow until it clicks into
place.
DC cord’s battery
connector
Removal
1
Set the POWER switch to OFF, and check
that the mode lamp is off.
Slide the DC cord’s battery connector to
the direction of the arrow while pressing
the battery release button.
Battery release button
Disconnect the AC power supply cord from
the power outlet.
CAUTION:
This apparatus can be operated at a voltage in
the range of 110 – 240 V AC.
Voltages other than 120 V are not intended for
U.S.A. and Canada.
Operation at a voltage other than 120 V AC may
require the use of a different AC plug. Please
contact either a local or foreign Panasonic
authorized service center for assistance in
selecting an alternate AC plug.