Polycom SpectraLink 1725-36034-001 User Manual
Page 31
![background image](/manuals/180675/31/background.png)
SpectraLink 8002 Wireless Telephone Configuration
PN: 1725-36034-001_B.doc
31
Security
*NONE
disables any 802.11 encryption or security authentication
mechanisms.
For WEP, WPA-PSK and WPA2-PSK set each of the following
options to match exactly the settings in the APs.
The encryption key or encryption passphrase displays as it is
entered. For security reasons codes will not display again once
entered, even if the entry screen is revisited.
WEP
(Wired Equivalent Privacy) is a wireless encryption protocol that
encrypts data frames on the wireless medium allowing for greater
security in the wireless network. If WEP is required at this site, you
must configure each handset to correspond with the encryption
protocol set up in the APs. Select the entries from the options below to
enable the handset to acquire the system.
Authentication
Select either
Open
System
or
Shared
Key
.
WEP On/Off
Select either
WEP Off
or
WEP
On
.
Key Information
Default
Key
Enter the key number specified for use by the
handsets. This will be
1
through
4.
Key
Length
Select either
40-bit
or
128-bit
depending on the key
length specified for use at this location.
Key 1 through 4
Scroll to the key option that corresponds to the
Default Key
that was entered above. Enter the encryption key as
a sequence of hexadecimal characters. (Use the
2
and
3
keys to
access hexadecimal digits A-F, use the Right Arrow key to
advance to the next digit, and the Left Arrow key to
backspace.) For 40-bit keys, enter 10 hex characters. For 128-bit
keys, enter 26 hex characters. The display will scroll as needed.
Rotation Secret
This is used for proprietary WEP key rotation. Refer
to your custom document if this feature is supported in your
system.
WPA-PSK
The security features of WPA (Wi-Fi Protected Access)
using PSK (pre-shared key) are available and may be used if
supported by the APs in the facility. Select either
Passphrase
and enter
a passphrase between eight and 63 characters in length or
Pre-shared
Key
and enter the 256-bit key code.