Polycom SpectraLink 1725-36034-001 - Manual (Page 13)

SpectraLink 8002 Wireless Telephone Overview
PN: 1725-36034-001_B.doc 13
Quick Start Guide
1. A wireless LAN must be properly configured and operational
through the use of 802.11 wireless APs. Ensure WMM is enabled
on the APs.
2. Configure a TFTP server on the LAN. The TFTP server is used to
load the handset software and SIP configuration files into the
handsets. See Chapter 2 SpectraLink 8002 Wireless Telephone
Configuration for DHCP information.
3. The supported SIP system components must be connected to your
network and completely operational.
4. Visit http://www.polycom.com/usa.en/support/voice/wi-
fi/spectralink_8002_wireless.html to download the latest handset
software and example SIP configuration files.
5. Ensure the handset software is properly loaded on the TFTP
server that has been designated for the handset code. See Chapter
3 Software License and Protocol Management, section Configuration
Process.
6. Create/modify configuration files on the SIP TFTP server to
define parameters for the SIP application. See Chapter 4
Programming the SIP Handset Features, section SIP TFTP Server
Configuration Files. The TFTP server may be the same one
referenced in step 2 above.
7. Configure your handset per Chapter 2 SpectraLink 8002 Wireless
Telephone Configuration. Ensure these configuration options are
set:
— Regulatory Domain
— SIP Registration, Reg 1 and Login
— IP Addresses: DHCP or static for each listed component,
including SIP TFTP server and TFTP server.
— Security
— Preferred Channels