beautypg.com

Introduction, Accessing the voice prompt, Existing voice prompt configuration – Patton electronic Patton SmartLink M-ATA User Manual

Page 86

background image

Introduction

86

SmartLink M-ATA Getting Started Guide

E • Voice prompt configuration

Introduction

The M-ATA provides the ability to review and set the network configuration parameters using the handset of
an attached analog telephone handset.

By default from the factory, DHCP is enabled and an IP address is not configured.

The M-ATA must be power cycled or reloaded after changing any of the network settings. Menu selection item
Network Status will not reflect setting changes until after M-ATA is reloaded or power cycled.

Note

Configuration of these settings can result in loss of connectivity to the M-
ATA on the local LAN.

Accessing the voice prompt

Dial **** from the analog handset to reach the main menu.

Existing voice prompt configuration

On hook the analog phone.

Access

Code

Main Menu

Selection

Announcement/

Function

Voice Prompt

User input

****

Main Menu

Plays main
menu selections

Patton SmartLink Con-
figuration Main Menu

Enter selection code

100#

Network status Plays DHCP setting, IP

address, gateway IP
address and IP network
mask setting

100# Network status

None.

110#

DHCP setting Enables or

Disables DHCP

110# DHCP Settings

1# to enable DHCP
2# to disable DHCP or “#” to
return to the main menu

120#

IP address

setting

Sets IP address of
the M-ATA

120# Set IP Address

Use “*” to instead of “.”, and
“#” to end.
Ex: 172*16*230*227# or
“#” to return to the main
menu

130#

Gateway

setting

Sets the gateway router IP
address

130# Set gateway
router IP address

Use “*” to instant of “.”, and
“#” to end or “#” to return to
the main menu

140#

Net mask

setting

Set the IP network mask

140# Set IP
network mask

Use “*” to instant of “.”, and
“#” to end or “#” to return to
the main menu

150#

Reload

Immediately reloads
the SmartLink

None

None