Introduction, Calling features – Patton electronic Patton SmartLink M-ATA User Manual
Page 84

Introduction
84
SmartLink M-ATA Getting Started Guide
D • Calling Features
Introduction
The SmartLink M-ATA family supports advanced calling features that can be turned on and off from phones
attached to the SmartLink M-ATA (see
).
Note
Your telephony service provider must enable your service for these calling
features to work.
Note
F in
refers to the hook flash event.
Table 3. Calling features
Feature
Keypad
Feature
Keypad
Call Hold
F1
Call Retrieve
F*
Conference
F7
Conference Drop
F8
Call Transfer
F4
Do not Disturb ON
*82
Do not Disturb OFF
#82
Distinctive ON
*90
Distinctive OFF
#90
Call Waiting ON
*91
Call Waiting OFF
#91
Incoming Caller ID Display ON
*92
Incoming Caller ID Display OFF
#92
Self Caller ID Block Service ON
*93
Self Caller ID Block Service OFF
#93
Anonymous Call Reject ON
*94
Anonymous Call Reject OFF
#94
Incoming Call Block ON
*95
Incoming Call Block OFF
#95
Call Forward Selective ON
*96
Call Forward Selective OFF
#96
Call Forward All ON
*97
Call Forward All OFF
#97
Call Forward Busy ON
*98
Call Forward Busy OFF
#98
Warm Line ON
*99
Warm Line OFF
#99
IP Dialing ON
*80
IP Dialing OFF
#80
Speed Dialing ON
*81
Speed Dialing OFF
#81
Call Return
*60
Config Warm Line Number
(*70
yyyyy where yyyyy = number to call)
*70
Config Speed Dialing Number
(*71
xyyyyy where x = speed dial key
and
yyyyy = number to call)
*71
Config IP Dialing
(*72
xxx*xxx*xxx*xxx*yyyy where xxx = IP
address and
yyyy = optional port number)
*72
Set Call Forward Number
(Wait for 3 short confirmation tones
before hanging up)
*73
Access Voicemail
*86