Patton electronic Patton SmartLink M-ATA - Manual (Page 55)

Localization 55
SmartLink M-ATA Getting Started Guide 6 • System
Localization
The Localization window contains the following sections:
• Call Progress Tones (see figure 32 on page 56)
• Distinctive Ring Setting (see figure 33 on page 57)
• Supplementary Service Keys (see figure 34 on page 58)
• Control Timer Values (see figure 36 on page 61)
• FXS Port (see figure 37 on page 62)
• Ring Setting (see figure 38 on page 63)
• FXS Port Polarity (see figure 39 on page 63)
Note After configuring the sections, click the Save button (see figure 39 on
page 63) to save the new configuration.
Call Progress Tones
The dialtone, confirmation, busy, ringback and offhook warning call progress tones that are played to the
handset can be set manually or the tones will be set automatically to the country specified under Call ID
method if the checkbox, Call Progress Tones synchronization has been selected.
To set the call progress tones manually specify:
[frequency 1]@[Energy 1]+[frequency 2]@[Energy 2]#ON([ms]),OFF([ms]),R
Where:
• Frequency 1 and frequency 2 are the frequency of the tone to be played.
• Energy 1 and energy 2 are the energy level of the tone to be played in dBm.
• ON(ms) is the duration that the tone will be played in milliseconds.
• OFF(ms) is the duration of the pause between cycles of playing the tone.
• R indicates the tone should be repeated using the ON and OFF durations specified