Patton electronic Patton SmartLink M-ATA - Manual (Page 27)

Settings 27
SmartLink M-ATA Getting Started Guide 4 • Network—LAN
IP address
The IP address of the SmartLink on the WAN interface.
MAC address
The MAC address of the WAN Ethernet interface in the SmartLink.
Subnet Mask
The subnet mask is 32-bit number that filters a destination IP address to determine to which subnet it belongs.
For example, a subnet mask of 255.255.0.0 for a network ID of 192.5.0.0 tells the switch to accept traffic des-
tined for IP addresses that begin with 192.5—all other packets are ignored.
Default Gateway
The IP address of the gateway. The gateway IP address can be retrieved automatically in DHCP mode or be set
up manually with a fixed IP address.
Domain name
The network domain name of the SmartLink.
DNS address
Refers to the address of your domain name server that was defined under LAN settings or that was learned
dynamically through DHCP.
DynDNS address
The IP address of the dynamic DNS server that will be notified when the SmartLink M-ATA’s dynamic IP
address changes.
VLAN
VLAN tag value encoded in the LAN Ethernet header in all outgoing packets
Priority Tag
Priority tag value encoded in the LAN Ethernet header in outgoing packets.
Settings
The Settings window contains the following sections:
• Internet Configuration (see figure 5 on page 28)
• WAN PPPoE Configuration (see figure 6 on page 29)
• MAC Spoofing Configuration (see figure 8 on page 30)
• Internet VLAN Configuration (see figure 8 on page 30)
Note After configuring the sections, click the Save Internet Settings button (see
figure 4 on page 26) to save the new configuration.