Patton electronic Patton SmartLink M-ATA - Manual (Page 59)

Localization 59
SmartLink M-ATA Getting Started Guide 6 • System
Do Not Disturb
Enables or disables the do not disturb feature.
IP Dialing
Enables or disables dialing by IP address.
Speed Dialing
Enables or disables the speed dialing feature.
Income Caller ID
Enables or disables the display of incoming caller ID feature.
Self Caller ID Block
Enables or disables the blocking of transmission of caller ID feature for outgoing calls.
Calling Prefix Keys
Calling Prefix Keys and other configuration parameters define the behavior of the calling feature.
Note Following function key must be start by ‘*’,’#’ character, or f (flash hook)
and follow a 1 or 2 numeric digit(s).
Figure 35. Calling Prefix Keys section of Localization Window
Call Return
Automatically places a call to the number of the last call received.
Warm Line
Configures the number to call automatically after a delay period once the telephone goes off hook. To config-
ure the warm line number enter the calling prefix key (*70 is the factory default), the number to dial and then
on hook the phone. You will hear a second dial tone after entering the calling prefix key. Before using warm-
line calling it must be enabled using the activate sequence defined in the supplementary service table.
Example:
*7013019751000 and on-hook the phone. When the handset is lifted, 301951000 will be called if another
number is not entered within the delay period specified under System > Localization.