Communication port, Communication, Communication port options – Paradyne M/HDSL Standalone Termination Unit Hotwire 7984 User Manual

Page 88: Table a-4, Unit

Configuration Option Tables

A-8

7984-A2-GB20-10

February 1999

Communication Port

For Communication Port Options, refer to Table A-4. To access the
Communications Ports screen, follow this menu selection sequence:

Main Menu

→

Configuration

→

Load Configuration From

→

Communication

Port

ООООООООООООООООООООООООО

main/config/commport

Hotwire

Model: 7984

COMMUNICATION PORT OPTIONS

Port Use:

Terminal

Port Type:

Asynchronous

Data Rate (Kbps):

9.6

Character Length:

Parity:

None

Stop Bits:

Ignore Control Leads:

Enable

Login Required:

Enable

Port Access Level:

Administrator

Inactivity Timeout:

Enable

Disconnect Time (Minutes):

–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

Ctrl-a to access these functions, ESC for previous menu

MainMenu

Exit

Table A-4.

Communication Port Options (1 of 3)

Port Use

Possible Settings: Terminal, Net Link
Default Setting: Terminal

Specifies how the communications port is to be used.

Terminal – The communication port will be used for the Asynchronous terminal
interface.

Net Link – The communication port will be used as the network communication link to
an IP network or device.

Port Type

Possible Settings: Asynchronous, Synchronous
Default Setting: Asynchronous

When Port Use is set to Net Link, Port Type controls whether the communication port
will be asynchronous or synchronous.

Asynchronous – Configures the communication port for asynchronous communication.

Synchronous – Configures the communication port for synchronous communication.