Paradyne M/HDSL Standalone Termination Unit Hotwire 7984 - Manual (Page 17)

2-1 7984-A2-GB20-10 February 1999
Using the Asynchronous Terminal
Interface
2
User Interface Access
You can communicate with the Hotwire 7984 Standalone Termination Unit with an
asynchronous terminal interface (ATI) using one of the following methods:
H Direct connection through the COM port of the standalone unit or through the
serial port of the DSLAM MCC.
H
Telnet session through the Embedded Operations Channel (EOC).
NOTE:
Only one terminal interface session can be active at a time, and another
user’s session cannot be forced to end. To automatically log out a user due to
inactivity, enable the Inactivity Timeout option (see Table A-5,
Telnet Session
Options , in Appendix A, Configuration Option Tables).
Security can limit ATI access several ways. To limit user access or set up login
IDs, refer to
Chapter 7, Security .
Communication Port Settings
Ensure that the device you connect communicates using these settings:
H
Data rate set to 9.6 kbps.
H Character length set to 8.
H
Parity set to None.
H
Stop Bits set to 1.