Configuring snmp traps – Paradyne M/HDSL Standalone Termination Unit Hotwire 7984 User Manual

Page 68

Messages and Troubleshooting

6-2

7984-A2-GB20-10

February 1999

Configuring SNMP Traps

An SNMP trap can be automatically sent out through the EOC or the
Management port to an SNMP manager when the 7984 Standalone Termination
Unit detects conditions set by the user. These traps enable the SNMP manager to
gauge the state of the network. Refer to Appendix B,

Standards Compliance for

SNMP Traps

, for details of SNMP traps supported by the 7984 Standalone

Termination Unit.

To configure the 7984 Standalone Termination Unit for SNMP traps, use the
SNMP Traps Options screen to:

Enable SNMP traps.

Set the number of SNMP managers that receive SNMP traps from the 7984
Standalone Termination Unit by entering an IP address and network
destination for each SNMP manager specified.

Select the type of SNMP traps to be sent from the 7984 Standalone
Termination Unit.

To configure SNMP Traps, follow this menu selection sequence:

Main Menu

→

Configuration

→

Load Configuration From

→

Management and Communication Options

→

SNMP Traps Options

ООООООООООООООООООООООООО

main/config/management/trap

Hotwire

Model: 7984

SNMP TRAPS OPTIONS

SNMP Traps:

Enable

Number of Trap Managers: 5

NMS 1 IP Address:

135.014.040.001

Clear

Destination: DSL

NMS 2 IP Address:

135.014.003.027

Clear

Destination: DSL

NMS 3 IP Address:

135.014.001.008

Clear

Destination: DSL

NMS 4 IP Address:

135.014.002.024

Clear

Destination: DSL

NMS 5 IP Address:

204.128.146.035

Clear

Destination: DSL

General Traps:

Both

Enterprise Specific Traps: Enable

Link Traps:

Both

Link Traps Interfaces:

Network

–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

Ctrl-a to access these functions, ESC for previous menu

MainMenu

Exit

Save

Refer to Table A-9,

SNMP Traps Options

to configure SNMP traps.