Paradyne M/HDSL Standalone Termination Unit Hotwire 7984 - Manual (Page 78)

Security
7-6 7984-A2-GB20-10 February 1999
If entering yes to prompt . . . Then . . .
Reset COM Port usage H Port type is set to Terminal
H Data Rate (kbps) is set to 9.6
H Character Length is set to 8
H Stop Bits is set to 1
H Parity is set to None
Reload Factory Defaults Yes (or y) will restore all factory-loaded
configuration and control settings contained in the
Default Factory Configuration area are loaded.
If no (or n) is entered, or if no selection is made within 30 seconds, the unit
returns to the condition or operation it was in when the system reset was
initiated, with the COM port rate returning to its configured rate.
The termination unit resets itself, going through a self-test. Connectivity is
restored and the Main Menu screen appears.