Snmp nms security options, A-21, Snmp traps options – Paradyne M/HDSL Standalone Termination Unit Hotwire 7984 User Manual

Page 100: Table a-9, Able a-9, To configure snmp traps, Snmp, Traps options, In appendix a, Configuration option tables

Configuration Option Tables

A-20

7984-A2-GB20-10

February 1999

SNMP Traps Options

SNMP configuration options allow you to specify the information necessary to
support the 7984 termination unit SNMP traps. To access the SNMP Traps
Options screen, follow this menu selection sequence:

Main Menu

→

Configuration

→

Load Configuration From

→

Management and Communication

→

SNMP Traps

ООООООООООООООООООООООООО

main/config/management/trap

Hotwire

Model: 7984

SNMP TRAPS OPTIONS

SNMP Traps:

Enable

Number of Trap Managers: 5

NMS 1 IP Address:

135.014.040.001

Clear

Destination: IMC

NMS 2 IP Address:

135.014.003.027

Clear

Destination: IMC

NMS 3 IP Address:

135.014.001.008

Clear

Destination: IMC

NMS 4 IP Address:

135.014.002.024

Clear

Destination: IMC

NMS 5 IP Address:

204.128.146.035

Clear

Destination: IMC

General Traps:

Both

Enterprise Specific Traps: Enable

Link Traps:

Both

Link Traps Interfaces:

Network

–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

Ctrl-a to access these functions, ESC for previous menu

MainMenu

Exit

Save

Table A-9.

SNMP Traps Options (1 of 3)

SNMP Traps

Possible Settings: Enable, Disable
Default Setting: Disable

Controls the generation of SNMP trap messages. The options for addresses and types
of traps are located in this table.

Enable – SNMP trap messages are sent out to SNMP managers.

Disable – No SNMP trap messages are sent out.

Number of Trap Managers

Possible Settings: 1, 2, 3, 4, 5
Default Setting: 1

Sets the number of SNMP management systems that will receive SNMP traps.

1 to 5 – Number of trap managers. An NMS IP address is required for each manager.