Panasonic VQT2H52 - Manual (Page 127)

127
VQT2H52
Problem Check points
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
≥ Turn on the power again. If normal conditions are not
restored yet, remove the battery or AC adaptor, wait about
1 minute and then reconnect the battery or AC adaptor.
Then about 1 minute later, turn on the power again.
(Conducting the above operation while the media is being
accessed may damage the data on the media.)
≥ If normal operation is still not restored, detach the power
connected, and contact consumer support. ( l 145)
Recording does not start
although power is
supplied to this unit and
the SD card is correctly
inserted. ≥ A message is displayed and you cannot record when the
built-in memory does not operate normally, or when the SD
card cover cannot be closed due to failure of the SD card
cover. In this case, press the recording start/stop button to
display the media change message, allowing you to change
the recording media.
Item other than the
touched one is selected. ≥ Calibrate the touch screen. ( l 37)
The remaining time
indication or the elapsed
time indication is not
shown. ≥ If you set [SETUP] > [DISPLAY] > [OFF], indications
other than warnings and date etc. are not displayed. ( l 31)
The unit arbitrarily stops
recording. ≥ Use an SD card that can be used for motion picture
recording. ( l 24)
When the unit stops while a usable SD card for recording
motion pictures (
l 24) is used, the data writing rate has
deteriorated. We recommend formatting the SD card being
used. (
l 89)
≥ If [AGS] is [ON], record in the normal horizontal position or
set [AGS] to [OFF]. ( l 58)
≥ Repeated recording and deletion of motion pictures may
reduce the usable time for recording on a media you use. In
that case, format the media.
AF tracking does not
work when the object is
touched. ≥ Touch the part of the object that has specific color such as
the part that is different from the surrounding. ( l 51)
Auto focus function does
not work. ≥ Set the Intelligent auto mode to on or off.
≥ If you are trying to record a scene which is hard to bring into
focus in Auto Focus mode, use the Manual Focus mode to
adjust the focus. (
l 40, 69)
HDCSD10_TM10_TM15P-VQT2H52_eng.book 127 ページ ２００９年７月６日 月曜日 午後１時４６分