Patton electronic 2710 - Manual (Page 6)

6
FCC Compliance
The Model 2710 has been tested and found to comply with the speciÞca-
tions found in Part 68 of the FCC rules and regulations. A label on the
equipment bears the FCC registration number. You may be requested to
provide this information to your telephone company.
The telephone company may decide to temporarily discontinue your ser-
vice if they believe that the Model 2710 may cause harm to the telephone
network. Whenever possible the telephone company will attempt to
notify you in advance. You have a right, if you so choose, to Þle a com-
plaint with the FCC.
In accordance with FCC rules and regulation CFR 47 68.218(b)(6), the
user must notify the telephone company prior to disconnection.
The Universal Service Order Code (USOC) is RJ48.
The Facility Interface Codes (FIC) are 04DU9-BN, 04DU9-DN, 04DU9-
1KN, and 04DU9-1SN.
The Service Order Code (SOC) is 6.0N
1.5 INDUSTRY CANADA NOTICE :
The Canadian Department of Communications label identiÞes certiÞed
equipment. This certiÞcation means that the equipment meets certain
telecommunications network protective, operational and safety require-
ments. The Department does not guarantee the equipment will operate
to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissi-
ble to be connected to the facilities of the local telecommunications com-
pany. The equipment must also be installed using an acceptable method
of connection. In some cases, the company’s inside wiring associated
with a single line individual service may be extended by means of a certi-
Service
Facility
Interface
Code
Service
Code
Network
Connection
1.544 Mbps SF format without line power 04DU9-BN 6.0N RJ48C
1.544 Mbps SF and B8ZS without line
power 04DU9-DN 6.0N RJ48C
1.544 Mbps ANSI ESF without line power 04DU9-1KN 6.0N RJ48C
1.544 Mbps ANSI ESF and B8ZS w/o line
power 04DU9-1SN 6.0N RJ48C