Patton electronic 2710 - Manual (Page 5)

5
1.3 RADIO AND TV INTERFERENCE
The NetLink-T1™ Model 2710 Series generates and uses radio fre-
quency energy, and if not installed and used properly—that is, in strict
accordance with the manufacturer's instructions—may cause interfer-
ence to radio and television reception. The Model 2710 Series has been
tested and found to comply with the limits for a Class A computing device
in accordance with the speciÞcations in Subpart J of Part 15 of FCC
rules, which are designed to provide reasonable protection from such
interference in a commercial installation. However, there is no guarantee
that interference will not occur in a particular installation. If the Model
2710 Series does cause interference to radio or television reception,
which can be determined by disconnecting the cables, the user is
encouraged to try to correct the interference by one or more of the follow-
ing measures: moving the computing equipment away from the receiver,
re-orienting the receiving antenna, and/or plugging the receiving equip-
ment into a different AC outlet (such that the computing equipment and
receiver are on different branches).
1.4 FCC INFORMATION
The Model 2710 Series has been tested and registered in compliance
with the speciÞcations in Part 68 of the FCC rules. A label on the equip-
ment bears the FCC registration number. You may be requested to pro-
vide this information to your telephone company.
Your telephone company may make changes in its facilities, equipment,
operations or procedures that could affect the proper operation of the
Model 2710 Series. If this happens, the telephone company should give
you advance notice to prevent the interruption of your service.
The telephone company may decide to temporarily discontinue your ser-
vice if they believe your Model 2710 Series may cause harm to the tele-
phone network. Whenever possible, they will contact you in advance. If
you elect to do so, you have the right to Þle a complaint with the FCC.
If you have any trouble operating the Model 2710 Series, please contact
Patton Technical Support at (301) 975-1007. The telephone company
may ask you to disconnect the equipment from the telephone network
until the problem has been corrected or until you are certain that the
Model 2710 Series is not malfunctioning.
The following information may be required when applying to your local
telephone company for leased line facilities: