Panasonic BB-HCM381A - Manual (Page 152)

Operating Instructions
152
5.4 Controlling External Output
The external output terminal allows you to control the external devices. You can
also change the initial status of the output signal.
1. Click [External Output] on the Setup page.
2. Click [Save] when finished.
• Clicking [Cancel] cancels your settings without saving changes.
• The new settings are saved.
• When finished, "Success!" is displayed.
3. Click [Go to External Output Control page].
• The External Output Control page is displayed.
Setting Description
External Device
Control Output • If you check [Open], the internal transistor turns off and the
external output terminal gets high impedance (open
collector) when the camera powers up. If you check [Short
to GND], the internal transistor turns on and is electrically
short-circuited to GND pin when the camera powers up.
The external output terminal gets low impedance (0 V).
Button name
modification • You can change the output control button names on the
operation bar. You can name the button depending on your
external devices.