Installation, Figure 4-5, Pri network interface module (peripheral side) – Polycom ViewStation EX4000 User Manual
Page 94: Figure 4-6, Pri network interface module (network side)
Integrators’ Reference Manual for ViewStation EX, ViewStation FX, and VS4000
84
www.polycom.com
Installation
To install the PRI network interface module:
1.
Ensure that the system is powered off.
2.
Connect peripheral side of the PRI network interface module to
the system using the supplied cable. Figure 4-5 shows the
peripheral side of the PRI network interface module.
Figure 4-5.
PRI Network Interface Module (Peripheral Side)
3.
Connect the 12-volt DC power supply to the PRI network
interface module and then to the UPS or wall outlet.
4.
Connect the PRI network interface module to the ISDN
network.
Figure 4-6.
PRI Network Interface Module (Network Side)
You are now ready to power on and configure the system.
Port
(not used)
Input Port
LEDs
Network
Connector
LEDs