beautypg.com

Mechanical trouble shooting, Fabric – Paxar 545 User Manual

Page 74

background image

72

Mechanical Trouble Shooting

Users Manual Model 545™

Mechanical Trouble Shooting

Fabric

Problem

Probable Cause

Corrective Action

Fabric will not roll or jumps 1) Incorrect adjustment of unwind

web guides

1) Be sure fabric roll is as flat as possible and does

not extend over core.

2) Adjust the web guides to touch the fabric roll

without pinching the core.

Fabric jams in bridge blade

rollers or knife area.

1) Knife mounted bridge blade too

close to stationary bridge blade.

1) Loosen screws in upper knife securing bridge

blade roller assembly and slide up (holes in
blade are slotted) until rollers just contact
fabric. Tighten screws.

2) Knife not cutting full width of

fabric.

1) Loosen knife shear adjustment screws and move

outer end of knife until full cut is accomplished.

3) Stacker not operating or nip rollers

not turning.

1) Be sure the nip roller is free to rotate and moves

easily in the bearing slots.

Will not stack.

1) Stacker not operating.

1) See step 3 above.

3) Incorrect rail position or stacker

bed angle.

1) Using a cut label, position stacker rails so that

approximately 3/8" (9.5mm) overhangs the
second grooved roller. Loosen quick-turn
handle on stacker clamp and raise or lower
stacker bed until opening between 1st label
overhang and belt surface will allow entry of
next label.

Knife will not cut or partial

cut

1) Incorrect pre-load on clutch pawl.

1) With back cover removed and power off -

operate solenoid by hand. When lever is
moved, clutch pawl should move counter-
clockwise about 1/32" (0.79mm) with the "pac-
man" in home position. If not - loosen "pac-
man" set screws and readjust "pac-man" to stop
with spring in detent.

2) Partial cut

1) Loosen shear adjustment screws and move outer

end of knife until full cut is obtained.