Paxar 545 - Manual (Page 52)

50 • Control Panel Operation Users Manual Model 545™
B O T R E F L O V E R M A R K
V A L U E : 0 0 0 N E W V A L U E : 0 0 0
This screen follows the "TOP REFL NOT OVER MARK" screen. Place the fabric
over the bottom reflective sensor so that the reflective mark is over the sensor and
when NEW VALUE is at the highest value press ‘Enter’.
Pressing the MODE / Down Arrow key will take the user to the "BOT REFL NOT
OVER MARK" screen. Pressing the EXIT / Up Arrow key will take the user back
to the "HOME" screen.
B O T R E F L N O T O V E R M A R K
V A L U E : 0 0 0 N E W V A L U E : 0 0 0
This screen follows the "BOT REFL OVER MARK" screen. Place the fabric over
the bottom reflective sensor so that the fabric is over the sensor but the reflective
mark is not over the sensor and when NEW VALUE is at the lowest value press
‘Enter’.
Pressing the MODE / Down Arrow key will take the user to the "STACKER
BLOCKED" screen. Pressing the EXIT / Up Arrow key will take the user back to
the "HOME" screen.
S T A C K E R B L O C K E D
V A L U E : 0 0 0 N E W V A L U E : 0 0 0
This screen follows the "BOT REFL NOT OVER MARK" screen. Place the fabric
in the stacker jam sensor so that the fabric is within the sensor site path and when
NEW VALUE is at the highest value press ‘Enter’.
Pressing the MODE / Down Arrow key will take the user to the "STACKER NOT
BLOCKED" screen. Pressing the EXIT / Up Arrow key will take the user back to
the "HOME" screen.
S T A C K E R N O T B L O C K E D
V A L U E : 0 0 0 N E W V A L U E : 0 0 0
This screen follows the "STACKER BLOCKED" screen. Remove any fabric from
the stacker jam sensor so that no fabric is within the sensor site path and when NEW
VALUE is at the lowest value press ‘Enter’.
Pressing the MODE / Down Arrow key will take the user to the "STOCK OUT
BLOCKED" screen. Pressing the EXIT / Up Arrow key will take the user back to
the "HOME" screen.
S T O C K O U T B L O C K E D
V A L U E : 0 0 0 N E W V A L U E : 0 0 0
This screen follows the "STACKER NOT BLOCKED" screen. Place the fabric in
the stock out sensor so that the fabric is within the sensor site path and when NEW
VALUE is at the highest value press ‘Enter’.
Pressing the MODE / Down Arrow key will take the user to the "STOCK OUT NOT
BLOCKED" screen. Pressing the EXIT / Up Arrow key will take the user back to
the "HOME" screen.