beautypg.com

Paxar 545 User Manual

Page 48

background image

46

Control Panel Operation

Users Manual Model 545™

P R I N T

P O S I T I O N

S T A T I O N

2

V A L U E : ± X X

N E W

V A L U E : ± Y Y

This screen follows the "PRINT POSITION STATION 1" screen. This screen
allows the print position of station 2 to be adjusted in the feed direction.

The buttons are used to change the new print position value. The value
is displayed in a positive / negative format. The value ranges for XX and YY can be
from a -99 to a +99. Pressing ENTER will change the VALUE to the NEW
VALUE. A more positive number will move the print of station 2 to the right while
a more negative number will it to the left.

Pressing the MODE / Down Arrow key will take the user to the "PRINT OFFSET
STATION 1" screen. Pressing the EXIT / Up Arrow key will take the user back to
the "HOME" screen.

P R I N T

O F F S E T

S T A T I O N

1

V A L U E : ± X X

N E W

V A L U E : ± Y Y

This screen follows the "PRINT POSITION STATION 2" screen. This screen
allows the offset print position of station 1 to be adjusted.

The buttons are used to change the new print offset value. The value is
displayed in a positive / negative format. The value ranges for XX and YY can be
from a -20 to a +20. Pressing ENTER will change the VALUE to the NEW
VALUE. A more positive number will move the outboard half of the image printed
by station 1 to the right while a more negative number will move it to the left.

Pressing the MODE / Down Arrow key will take the user to the "PRINT OFFSET
STATION 2" screen. Pressing the EXIT / Up Arrow key will take the user back to
the "HOME" screen.

P R I N T

O F F S E T

S T A T I O N

2

V A L U E : ± X X

N E W

V A L U E : ± Y Y

This screen follows the "PRINT OFFSET STATION 1" screen. This screen allows
the offset print position of station 2 to be adjusted.

The buttons are used to change the new print offset value. The value is
displayed in a positive / negative format. The value ranges for XX and YY can be
from a -20 to a +20. Pressing ENTER will change the VALUE to the NEW
VALUE. A more positive number will move the outboard half of the image printed
by station 2 to the right while a more negative number will move it to the left.

Pressing the MODE / Down Arrow key will take the user to the "CHANGE CUT
POSITION" screen. Pressing the EXIT / Up Arrow key will take the user back to
the "HOME" screen.