Stacker label length adjustment, Stacker angle adjustment – Paxar 545 User Manual

Page 32

Text mode
Original mode

• Printer Operation / Adjustments

Users Manual Model 545™

Stacker Label Length Adjustment

• Loosen the “T” head thumbscrews on either side of the upright base.
• Slide the entire base to the desired position so that the cut label hangs over the

last belt roller approximately ¼” (6mm)

Stacker Angle Adjustment

• Turn the lock knob counter-clockwise to allow the stack end of the stacker to

rotate.

• Once the stack is so that the stacker rails are approximately 5° to 30° off

horizontal, tighten the lock knob by turning it clock-wise.