Paxar 545 - Manual (Page 50)

48 • Control Panel Operation Users Manual Model 545™
P R E S S E N T E R F O R
C L E A N I N G S T A T I O N 2
This screen follows the "CLEANING STATION 1" screen. This screen allows the
user to initiate a cleaning cycle for station 2. Pressing ENTER will initiate a
cleaning procedure on station 2 based on it’s default cleaning level setting.
Pressing the MODE / Down Arrow key will take the user to the "CHANGE
DEFAULT CLEANING LEVEL STATION 1" screen. Pressing the EXIT / Up
Arrow key will take the user back to the "HOME" screen.
C H A N G E D E F A U L T C L E A N I N G
L E V E L F O R S T A T I O N 1 : X X
This screen follows the "CLEANING STATION 2" screen. This screen allows the
user to adjust the default cleaning level for station 1.
The ENTER button is used to change the cleaning level value. The value is
displayed in a positive format. The value for XX can be either 3 or 4. Pressing
ENTER will toggle between the two values. The higher the value - the more
extensive the cleaning procedure will become.
Pressing the MODE / Down Arrow key will take the user to the "CHANGE
DEFAULT CLEANING LEVEL STATION 2" screen. Pressing the EXIT / Up
Arrow key will take the user back to the "HOME" screen.
C H A N G E D E F A U L T C L E A N I N G
L E V E L F O R S T A T I O N 2 : Y Y
This screen follows the "CHANGE DEFAULT CLEANING LEVEL STATION 1"
screen. This screen allows the user to adjust the default cleaning level for station 2.
The ENTER button is used to change the cleaning level value. The value is
displayed in a positive format. The value for XX can be either 3 or 4. Pressing
ENTER will toggle between the two values. The higher the value - the more
extensive the cleaning procedure will become.
Pressing the MODE/Down Arrow key will take the user to the "STATION
ACTIVATION" screen. Pressing the EXIT / Up Arrow key will take the user back
to the "HOME" screen.
S T A T I O N A C T I V A T I O N X X
C L O S E H E A D S P R E S S E N T E R
This screen follows the "CHANGE DEFAULT CLEANING LEVEL STATION 2"
screen. This screen allows the user to enable or disable the print stations.
The ENTER button is used to change the value. The value is displayed in a positive
format. The values are 1, 2, or 12. Pressing ENTER will continuously cycle though
the values.
Pressing the MODE / Down Arrow key will take the user back to the "CLEAN
STATION 1" screen. Pressing the EXIT / Up Arrow key will take the user back to
the "HOME" screen.