Panasonic WJ-SX650 - Manual (Page 95)

95
SPECIFICATIONS
■ Matrix Switcher WJ-SX650 Series
Power Source: 120 V AC, 60 Hz
Power Consumption: 60 W
Ambient Operating Temperature: –10 °C to +50 °C {14 °F to 122 °F}* 1
* In the constant operation
Ambient Operating Humidity: Less than 90 %
Video Input Board: x 1
Camera Input (CAMERA IN 1 to 32): 1 V [P-P]/75
Ω (BNC x 32), composite video signal
0.5 V [P-P]/75 Ω data signal and 2.5 V [P-P]/75 Ω vertical timing pulse multi-
plexed
Video Output (VIDEO OUT 1 to 4): 1 V [P-P]/75
Ω (25-pin D-sub connector x 4)* 2 , active loop-thru output
Alarm Input (ALARM IN): N.O. (Normally Open contact) or N.C. (Normally Close contact) selectable x 32
(37-pin D-sub connector)
RS-485 (Camera) Port: 6-conductor modular jack x 4 (2-wire or 4-wire communication, With termination
switches (MODE 1 to 4))
Extension Port (EXTENSION IN 2, 3): 37-pin D-sub connector x 2
Video Output Board: x 1
Monitor Output (MONITOR OUT 1 to 16): 1 V [P-P]/75
Ω (BNC x 16)
Data Port (DATA 1 to 4)
DATA 1, 2: Terminal Mode (TMNL)/PS·Data (PS·DATA) selectable
DATA 3, 4: Terminal Mode (TMNL)/Digital disk recorder (HDR) selectable
6-conductor modular jack x 4 (With termination switches (MODE 1 to 4))
Alarm Output (ALARM OUT 1, 2)
Alarm Output: Open collector output x 32, Max. 24 V DC, 100 mA
Alarm Recover Output: Non-voltage make contact input x 16
Time Adjust Input*
3 : Non-voltage make contact input x 1
Time Adjust Output* 3 : Open collector output x 32, Max. 24 V DC, 100 mA
Extension Port (EXTENSION 1 IN, OUT)* 3 : 6-conductor modular jack x 2 (With a termination switch (TERM: ON, OFF))
VS Input*3: 1 V [P-P]/75 Ω (VS IN)
VS Output*3 (VS OUT (THRU)): VS loop-thru output
(VS OUT): 1 V {P-P}/75
Ω (VS)
Serial Port*: 9-pin D-sub connector x 2
Expansion slot: x 1
RS-485 (Camera) Port*: 6-conductor modular jack x 4 (2-wire or 4-wire communication, With termination
switches (MODE 1 to 4))*
2
Functions: Monitor control (Camera selection, tour sequence, group sequence, group pre-
set, OSD display)
Camera/Receiver control (Coaxial/RS-485 communication)
Recorder control
Alarm control (Alarm event, Alarm ACK, Alarm reset, Alarm suspension, Alarm
History Display)
Timer event, Camera event
Dimensions: 420 mm (W) X 265 mm (H) X 372 mm (D)
{16-9/16" (W) X
10-2/5" (H) X 14-3/5" (D)} (excluding rubber feet and projections)
Weight: 19.0 k g ( 42 lbs.)
* 1 In the constant operation
* 2 Available only when Video Input Board WJ-PB65C32 is mounted
* 3 Not available when the MODE switches are set as Video Output Board 2