Philips DVDR 80 - Manual (Page 100)

88
Sound settings
Depending on the audio outputs being used, this menu provides you with a selection of settings.
If you are only using the analog audio outputs (red and white OUT L AUDIO R , OUT
AUDIO LR jacks), select 'Off' in the 'Digital output' menu.
Sound
Digital output All
Analog output Stereo
Night mode Off
' Digital output'
You can select from the following settings for devices connected to the DIGITAL AUDIO
OUT jack:
' All' : Dolby Digital and DTS signals are going out unchanged to the digital output. MPEG-2
multi-channel signals are converted to PCM (Pulse Code Modulation).
Use receivers/amplifiers with a digital multi channel sound decoder.
' PCM only' : Dolby Digital and MPEG-2 multi-channel signals are converted to PCM (Pulse Code
Modulation).
For receivers/amplifiers without a digital multi channel sound decoder.
' Off' : digital output is off.
For devices with an analog audio input.
' Analog output'
You can select from the following settings for devices connected to the analog outputs ( OUT L
AUDIO R , OUT AUDIO LR ).
' Stereo' : For devices that use neither DolbySurround nor TruSurround. Only use this setting
when the DVD Recorder is connected to a stereo TV.
' Surround' : Dolby Digital and MPEG-2 multi-channel are mixed to a Dolby Surround-compatible
two-channel output signal.
For devices with a Dolby Surround / Pro Logic decoder .
' Night mode'
Night mode optimizes the sound dynamics at low volume. This causes less disturbance in quiet
environments. This setting only functions with Dolby Digital Audio on DVDs.
User preferences