Polycom TransTalk 9000-Series User Manual
Page 344
Feature Reference
5-234
4. Press
e
to start the restore.
If the system detects an error before beginning the restore, the bottom line
of the display shows one of the following messages:
Insert Card
or
Bad File
or
Incompat Version
or
Empty File
(See Chapter 6, ‘‘Troubleshooting’’, for more information about these
messages.)
If the system does not detect an error, the restore begins.
When the restore has completed successfully, the bottom line of the
display shows
Restore Complete
for two seconds. Then the system
resets itself, which means that all calls in progress are disconnected. You
are no longer in System Programming mode.
If the restore is not successful, the display shows
Restore Failed or
Restore Failed-Try Again
for two seconds. All calls that were in progress
are disconnected and all of the system and telephone programming
settings revert to the default settings. You are no longer in System
Programming mode. Try the restore again.