Polycom TransTalk 9000-Series - Manual (Page 326)

Feature Reference
5-216
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To restrict an extension from making or receiving calls on all the lines in a specific
pool:
1. Press f 0 0 s s # 3 1 5 .
2. Enter the number of the extension to be programmed. For example, to
program extension 23, press 2 3 . A display similar to the following
appears:
Pool Access Rstr 23
Pool:
3. Enter the pool number (880, 881, 882, or 883) to be restricted at this
extension. For example, to restrict pool 881, press 8 8 1 . The current
restriction displays.
4. To change the pool restriction for this extension, press D until the
appropriate value displays—see “Valid Entries” on the previous page.
5. At this point:
To restrict another pool at this extension, press n or p until
the pool number shows on the display. Then repeat Step 4.
To restrict another extension, press N or P and begin
at Step 2.
6. Select another procedure or exit programming mode.