Polycom TransTalk 9000-Series - Manual (Page 179)

Caller ID Log Answered Calls (#317)—Release 2.0 or
Later
5-69
■
To view the Caller ID Call Log, a Caller ID Call Logging and Dialing
button must be programmed on a button with lights on a system display
phone. (This feature will not work if it is programmed on a button without
lights.)
Valid Entries
1 = Active (answered calls logged)
2 = Not active (answered calls are not logged)
✔
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To program the extension to log answered calls:
1. Press f 0 0 s s # 3 1 7 at extension
10 or 11.
2. Enter the number of the extension to be programmed. For example, to
program extension 12, press 1 2 .
3. To set Caller ID Log Answered Calls, press D until the appropriate
value displays. (See “Valid Entries.”)
4. To set Call ID Log Answered Calls for another extension, press n or
p until the extension number shows on the display. Then repeat
Step 3.
5. Select another procedure or exit programming mode.