Lowrance electronic 5200C - Manual (Page 27)

21
though the hole from the top. If you wish, you can fill in the hole around
the cables with a good marine caulking compound. Some marine dealers
stock cable hole covers to conceal the opening.
No matter what type of installation you prefer, be sure to leave enough
slack in the cables to allow tilting or swiveling the GlobalMap. If you
choose to fill in the hole, be sure to position the cables against the rear
edge of the hole as you apply the fill material.
Before positioning the bracket, be sure to hold the cables against the
rear edge of the hole. Then, slide the bracket over the hole and butt the
rear of the bracket base firmly against the cables, thus pinning them in
place against the side of the hole. Finally, fasten the bracket to the
dash. Attach the unit to the gimbal bracket using the supplied gimbal
knobs and washers.
In-Dash Installation
You can mount the GlobalMap in the dash with an optional FM-5
In-Dash Adapter Kit. The kit includes mounting hardware,
a template for cutting the hole and an instruction sheet, part
988-0147-43.
In-dash mounting template for the GlobalMap 5200c, showing
dimensions. NOTE: The figure above is not printed to scale. A scaled
template (FM-5 In-Dash Adapter Kit instructions) is available for free
download from our web site, www.lowrance.com.
113.5
[4.46]
Millimeters
[Inches]
ALWAYS VERIFY DIMENSIONS
In-Dash
Template
R 7.9
[0.31]
146.5
[5.76]
Top