Lowrance electronic 5200C - Manual (Page 136)

130
You shouldn't need this command if you are connecting your unit to a
network with similar display units and/or a series of electronic probes.
Restore Defaults
The Restore Defaults command allows you to reset an individual EP-10
Fuel Flow Sensor's settings to factory defaults. If, for example, you exe-
cute the Restore Defaults command from your Port Fuel Flow Ad-
vanced Options menu, only the settings for the Port Fuel Flow will be
reset to factory defaults. Other fuel flows on the network will not be
affected.
To restore default settings:
1. Press
MENU| MENU
, use ↑ ↓ to select
NMEA 2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Use
↑ ↓ to select the desired fuel flow and press
ENT
. The Device
Configuration menu will appear.
4. Highlight
A
DVANCED
O
PTIONS
and press
ENT
.
5. Select
R
ESTORE
D
EFAULTS
and press
ENT
. The following message will
appear: Are you sure you wish to change this device's configuration?
6. Highlight
Y
ES
and press
ENT
. Press
EXIT
repeatedly to get back to the
main display.
EP-15 Fluid Level Configuration
To input Device Name:
1. Press
MENU| MENU
, use ↑ ↓ to select
NMEA 2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select a fluid level you want to rename and press
ENT
. The Device
Configuration menu will appear with the Device Name dialog box high-
lighted.
4. Press
ENT
and use ↑ ↓, ← → to input the desired name for the fluid
level. Press
ENTER
. Press
EXIT
repeatedly to get back to the main dis-
play.