Lowrance electronic 5200C User Manual
Page 147
141
9. Fill up your tank again, noting how much fuel you added to the tank.
Compare that number to the Fuel Used figure displayed on the page
you customized. If the amount of fuel you added to the tank and the
fuel used figure are off by more than 3 percent, we recommend the en-
gine interface be calibrated.
NOTE:
You must use the gauge's Fill Tank command when filling your fuel
tank to keep the engine interface updated with correct information
on the amount of fuel in the tank.
To calibrate a Suzuki Engine Interface:
10. If calibration is necessary, press
MENU
|
MENU
, select
NMEA
2000
and
press
ENT
.
11. Highlight
F
UEL
M
ANAGEMENT
and press
ENT
.
12. Select
T
ANK
L
OCATION
and press
ENT
to choose the location of the tank
connected to the selected engine interface. Press
ENT
.
13. Highlight
F
ILL
T
ANK
and press
ENT
. The following message will ap-
pear: Are you sure you wish to Fill Tank? Select
Y
ES
and press
ENT
.
14. The following message will appear: Do you wish to re-calibrate the
device? Select
Y
ES
and press
ENT
.
15. Repeat these steps for each engine interface you want to calibrate.
Engine Trim Calibration
Engine Trim is calibrated through the Suzuki Engine Interface Device
Configuration menu.
1. Press
MENU
|
MENU
, select
NMEA
2000
and press
ENT
.
2. Choose
B
US
S
ETUP
and press
ENTER
. Select the Suzuki Engine Inter-
face connected to the desired engine and press
ENT
.
3. Highlight
C
ALIBRATE
T
RIM
and press
ENT
. The Device Calibration win-
dow will appear with a list of Calibration Instructions.
4. Highlight
S
TART
C
ALIBRATION
and press
ENT
. The following message
will appear: Please fully raise the Engine Trim.
5. After engine trim has been fully raised, press
ENT
. The following
message will appear: Please fully lower the Engine trim.
6. After engine trim has been fully lowered, press
ENT
. A Calibration
Completed message will appear. Press
ENT
.
7. Repeat these instructions to adjust the engine trim for each engine
connected to a Suzuki Engine Interface. Press
EXIT
repeatedly to return
to the main display.