LSI MegaRAID SCSI 320-2 RAID Controller Series 518 - Manual (Page 86)

6-14 Hardware Installation
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Figure 6.7 MegaRAID Controller with Backup Battery Module
6.2.7.1 Configuring the Battery Pack
After you install the MegaRAID controller you must configure the battery
pack in the BIOS Configuration Utility. To do this, you select the Objects
menu, then select Battery Backup.
Table 6.6 explains the battery backup
menu options.
Table 6.6 Backup Battery Menu Options
Menu Item Explanation
Battery Pack PRESENT appears if the battery pack is properly installed;
ABSENT if it is not.
Temperature GOOD appears if the temperature is within the normal range.
HIGH appears if the module is too hot.
Voltage GOOD appears if the voltage is within the normal range. BAD
appears if the voltage is out of range.
Fast Charging COMPLETED appears if the fast charge cycle is done.
CHARGING appears if the battery pack is charging.
No. of Cycles Must be configured when you first install a battery pack. When
you select this option, a small pop-up window appears asking
if you want to reset the charge cycles. Select YES to reset the
number of cycles to zero.
After 1100 charge cycles, the life of the battery pack is
assumed to be over and you must replace it.