LSI MegaRAID SCSI 320-2 RAID Controller Series 518 - Manual (Page 77)

Installation Steps 6-5
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
6. You can now add or remove DRAM modules from the MegaRAID
controller, as described above.
7. Reattach the battery pack harness to J10 on the MegaRAID
controller.
8. Reinstall the MegaRAID controller in the computer. Follow the
instructions in this chapter.
9. Replace the computer cover and turn the computer power on.
6.2.3.2 Recommended Memory Vendors
Call LSI Logic Technical Support at 678-728-1250 for a current list of
recommended memory vendors.
6.2.4 Step 4: Check Jumper Settings
Make sure the jumper settings on the MegaRAID SCSI 320-2 card are
correct. The jumpers are set at the factory and you probably do not need
to change them.
Table 6.2 lists the jumpers that you should check.
Figure 6.2 shows the location of these items on the MegaRAID SCSI
320-2 controller.
Table 6.2 Jumpers for the MegaRAID SCSI 320-2
Item Description Type
J2 SCSI activity LED connector 4-pin header
J3 Write pending indicator 2-pin header
J4 SCSI Termination Enable Channel 0 3-pin header
J5 SCSI Termination Enable Channel 1 3-pin header
J10 Battery connector 3-pin header
J16 BIOS Enable 2-pin header
J17 Termination Power Channel 0 2-pin header
J18 Termination Power Channel 1 2-pin header