Lanier JP1030 - Manual (Page 42)

Operation
30
1
Printing on Thick or Thin Paper
When you make prints on thick (127.9
to 209.3g/m
2 , 34.0 to 55.6 lb), stan-
dard (52.3 to 127.9g/m 2 , 13.9 to 34.0
lb) or thin (47.1 to 52.3g/m 2 , 12.5 to
13.9 lb) paper, perform the following
steps.
Pressure Lever Position
AAAA
Shift the feed roller pressure le-
ver to the Thick, Standard, or
Thin paper position.
Note
❒ Shift the lever according to the
paper weights as shown in the
following table.
*1 When paper is smaller than B5,
5
1 /
2
" × 8 1 /
2
" and heavier than
81.4g/m 2 (21.6 lb), move the
feed roller pressure lever to the
Thin paper position.
BBBB
Make sure that paper feed side
plates touch the paper lightly.
CCCC
When you finish prints, shift the
feed roller pressure lever to the
Standard paper position.
Metric
Version Inch
Version
Thick 127.9 —
209.3g/m
2
34.0 —
55.6 lb
Standard 52.3 —
127.9g/m
2
13.9 —
34.0 lb
Thin *1 47.1 —
52.3g/m
2
12.5 —
13.9 lb
ZCTH150E
PinkGold-F_V4_FM.book Page 30 Tuesday, September 11, 2001 6:31 PM